Garage Door Cable Repair in Glendale, CO

Yes - a same-day fix in most cases. Symptoms: the door hangs at an angle, barely opens then stops, or you heard a loud bang followed by the door dropping a few inches. The tech re-spools the cable on the drum, tests tension, and replaces both cables if either is frayed.

Usually a dead remote battery, a remote that needs reprogramming, or a receiver issue in the opener head. We carry universal remotes and keypads that work with LiftMaster, Chamberlain, Genie, Marantec, Craftsman, and most older Wayne Dalton units - reprogramming is a 10-minute job on any service call.

The two photo-eye sensors near the floor must see each other in a straight line. Common causes: one knocked out of alignment, a dirty lens, a kinked wire, or sun glare. Wipe both lenses and check alignment; if that doesn't fix it, a sensor or the wire run is bad and we replace it on-site.

Yes - single-car 8x7 and 9x7, double-car 16x7, and oversized 18-footer and 14-foot RV doors. Custom doors take longer lead time on the door itself, but install is the same day as delivery. Every new-door quote starts with a free on-site measurement and a written firm price.

Often, yes - if the rest of the door is structurally sound and we can source a matching panel. Single-panel replacement is meaningfully cheaper than a full new door. The tech checks panel availability and color match during the free inspection.

Lubrication of hinges, rollers, springs, and bearings; a balance check; spring-tension adjustment if needed; hardware tightening; safety-sensor verification; a reverse-on-obstruction test; and a cable inspection - about 45 minutes on a typical two-car door.